| Operation |
A blip will occur when the clutch AND brarke pedal are pressed. Another blip request will be made ONLY when the clutch pedal is released |
| Blip % |
The target acclerator pedal % applied when blipping. Example: 50 % |
| Duration(ms) |
Time in milliseconds that the blip will be applied. Example: 200 ms |
| Buffer(ms) |
The minimum time in milliseconds between blip events. Default: 300 ms |
| Delay(ms) |
Time in milliseconds to wait AFTER a blip request has been made before the blip will occur. Default: 0 ms |
| Clutch Set % |
The clutch pedal position % PRESSED to trigger a clutch press. Example: 60 % (The clutch must be pressed in 60 % to trigger a clutch press) NOTE: Clutch Set is only Enabled for Clutch Mode = 1 OR 3. For vehicles with clutch pedal position sensors, not switches |
| Clutch Mode | Clutch Mode is set at the factory and is vehicle specific regarding the clutch switch OR pedal position sensor logic. |
| Clutch Modes |
Mode 0 = Clutch Switch(Pin 4) Active LOW (12V to 0V) Brake(Pin 3) Active High (0V to 12V) Mode 1 = Clutch(Pin 14) Active Low (5V to ClutchSet%) Brake(Pin 13) Active High (0V > 1.25V) Mode 2 = Clutch Switch(Pin 4) Active HIGH (0V to 12V) Brake(Pin 3) Active High (0V to 12V) Mode 3 = Clutch(Pin 14) Active Low (5V to ClutchSet%) Brake(Pin 3) Active High (0V > 12V) |